• Ultimate Exhaust Protection for Your Quick Latch Towing Mud Flaps: Gives hot exhaust a clean path straight through the flap, stopping the heat damage, soot buildup, and warping that happens when your exhaust exits right into a towing mud flap.
• Heavy Duty Stainless Steel Frame & Vented Outlet Plate: Stainless steel stands up to constant exhaust heat, soot, and road salt, and the honeycomb plate spreads the flow out so it never hammers one hot spot.
• Made Specifically for Shocker Quick Latch Towing Mud Flaps: Fits every configuration, including the 2" single rear wheel, 2.5" single rear wheel, and 2.5" dually setups.
• Complete Pair for Both Sides of Your Truck: One kit does both flaps, so a dual exhaust setup is finished in a single purchase.
• Choose the Exact Location on Your Flap: Nothing is pre-cut, so you mark and cut the opening exactly where your own exhaust tips are aimed.
• Clamped Two-Piece Design Locks Onto the Rubber: The frame and outlet plate sandwich the extra-thick 5/16" rubber on four carriage bolts with serrated flange nuts on both sides, so it stays put at highway speeds.
• Finished Opening Protects the Cut Edge: The stainless frame wraps and finishes the cut, leaving a clean, factory-looking opening instead of raw rubber exposed to the heat.
• Simple Install with Basic Hand Tools: No fabrication required – trace, cut, drill four holes, and bolt it together. Full illustrated instructions are included.
• What’s in the Box: Includes (2) stainless exhaust outlet frames, (2) honeycomb exhaust outlet plates, (8) carriage bolts, (16) serrated flange nuts, and illustrated installation instructions. Mud flaps are not included.
• Proudly Made in the USA: Manufactured domestically to give you the highest quality protection for your towing setup.

If your truck’s exhaust exits out the rear bumper, your towing mud flap is sitting right in the stream. Hot exhaust gas hits the rubber head-on, deflects back underneath the truck and trailer, and leaves you with soot, discoloration, and a flap that goes soft and wavy in the spot taking all the heat. The Shocker Quick Latch Mud Flap Dual Exhaust Outlet solves it the direct way by giving that exhaust a clean, framed path straight through the flap. This is an add-on accessory built specifically for the Shocker Quick Latch Towing Mud Flaps, and it ships as a complete pair with every piece of mounting hardware you need for both sides.

Each outlet is a two-piece stainless steel assembly with a frame on the outer face and a honeycomb vented outlet plate behind it. The two halves sandwich the extra-thick 5/16" rubber and clamp down on four carriage bolts with serrated flange nuts top and bottom, so the assembly stays tight at highway speeds. The stainless frame wraps and finishes the cut edge so no raw rubber is left exposed to the heat, and the honeycomb pattern breaks up the exhaust flow instead of letting it concentrate in one place. Because you mark and cut the opening yourself during installation, each outlet lines up exactly with your own exhaust tips rather than sitting at a fixed factory location. Installation takes basic hand tools, and the illustrated step by step instructions are included in every kit. Made in the USA.

California Residents: Proposition 65 Warning